Clarion FZ501 Manuel du propriétaire télécharger pdf (Page 9)

8

English

4. OPERATIONS

Basic Operations

Note:

• Refer to the diagrams in “3. CONTROLS”

when reading this chapter.

CAUTION

When the unit is turned on, starting and

stopping the engine with its volume

raised to the maximum level may harm

your hearings.

Be careful about adjusting the volume.

Power on / off

Notes:

• Start the engine before using this unit.

• Be careful about using this unit for a long

time without running the engine. If you

drain the car’s battery too far, you may not

be able to start the engine and this can

reduce the service life of the battery.

1. Start the engine. The power button / knob

illumination on the unit will light up.

Engine ON

position

2. Press the [CONTROL] knob on the front

panel or [SRC /

] button on the remote

control to turn on the power under standby

mode. The unit goes back to the last

status after power on.

3. Press and hold the [CONTROL] knob

(center long press) on the front panel,

and rotate the [CONTROL] knob choose

POWER OFF, then press the [CONTROL]

knob on the front panel to turn off the

power.

Or press and hold [SRC / ] button on

remote control to turn off the power.

Mute

Press the [MUTE] button on the remote

control to mute the volume from the unit.

Note:

Doing the operation above again or adjusting

volume will release muting.

RESET

Volume adjustment

Turn the [CONTROL] knob on the front

panel.

The adjustable range of volume is 0 to 40.

CAUTION

While driving, keep the volume level at

which external sounds can be heard.

Playing source selection

Press [CONTROL] knob on the front panel

repeatedly to choose desired playing source.

Notes:

• Playing source selection means selecting

work mode, such as RADIO mode and

AUX mode, etc.

Display system time

Press the [DISP] button on the remote

control to switch the display information,

system time and playing source.

RESET

Note:

* When the [RESET] button is pressed,

frequencies of radio stations, titles, etc.

stored in memory are cleared.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Commentaires sur ces manuels

Pas de commentaire