Clarion Platinum Sound Processor Guide de l'utilisateur Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
20
Advanced Bionics Auria/ Harmony
List of required parts
1
MLxi or MicroMLxS
2
iConnect™ Adaptor, available in two sizes
3
Auria/ Harmony speech processor
Pre-Fitting
Set audio mixing ratio to 50/50.
When using MLxi, it should be programmed for the
Advanced Bionics Auria/ Harmony speech processor
(see page 32).
Fitting with the user
1. Turn all equipment Off.
2. Remove the standard earhook by twisting it Off.
3. Hold the iConnect at the base and firmly press until it
clicks onto the speech processor.
4. Insert a size 10 zinc air battery into the iConnect.
Note: Only ZeniPower® batteries, available for purchase
through Advanced Bionics are certified for use with the
standard-sized iConnect.
5. Turn the volume down On the speech processor to avoid
transient sounds.
1
2
3
6. Switch the speech processor to the dedicated FM program
with audio mixing ratio 50/50.
7. Plug the MLxi or MicroMLxS into the iConnect. If
MicroMLxS is used, move the switch to the single green
dot position.
8. Gradually turn the volume On the speech processor up to
the normal level (usually 12:00).
9. Test the patient’s speech recognition in quiet with the CI
alone and then through the wireless FM system only (out
of range of the processor microphone). Performance
should be similar between these two conditions. If the FM
is too loud or too soft, the FM programming software from
Phonak may be required to optimize the FM volume level.
10. Evaluate FM benefit as well as the appropriateness of FM
settings through speech-recognition assessment in the
clinic and standardized questionnaires completed by the
recipient, family members and teachers.
Listening check
Plug the MLxi or MicroMLxS into the headset checker
(See page 12). Turn On the headset checker and FM
transmitter and you should hear the FM signal.
Plug the MLxi or MicroMLxS into an audioshoe attached
to a hearing instrument. Turn On the hearing instrument
and switch it to the FM program if required.
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Commentaires sur ces manuels

Pas de commentaire