Clarion OHM653 Spécifications

Warning!THE CLARION OHM653 OVERHEAD VIDEO MONITOR ISDESIGNED TO BE VIEWED BY REAR-SEAT OCCUPANTSONLY!CLARION VIDEO PRODUCTS ARE NOT INTENDED FORVIEWI

10 OHM6534. In some installations, the vehicle headliner mustmodified, and the bracket must be sandwiched betweenthe headliner and the roof. If

OHM653 115. Wiring the OHM653The following pages display wiring diagrams for variousOHM653 configurations.Read the following precautions bef

12 OHM653OHM653 with VS735 DVDDVDVCDCDMP3DOLBYDIGITALREMAINANGLECHPTRKABREPEATTITLESCNRDML/RPOWEROPENVS 735 DVDBlack - GroundDIN cable 1Red +12

OHM653 13 OHM653 with VS735 DVD and VDH910 VCPDVDVCDCDMP3DOLBYDIGITALREMAINANGLECHPTRKABREPEATTITLESCNRDML/RPOWEROPENVS 735 DVDVDH 910 VCPBl

14 OHM653Dome Light Wiring Connections:Negative-trigger dome light system:Negative-trigger OHM 653 dome light wiring:Original Factory Domelight

OHM653 156. TROUBLESHOOTINGNo picture.Press the [POWER] and [SOURCE] buttons to make sure themonitor is on and the proper input is selected.

16 OHM653LIMITED WARRANTY INFORMATIONFor USA and Canada onlyThis product is warranted against all defects in material workmanshipfor a period o

2 OHM6531. INTRODUCTIONThe Clarion OHM653 is a high-performance video monitordesigned specifically for the mobile environment. It isintended fo

OHM653 32. CARE AND MAINTENANCELiquids and the OHM653Keep all liquids, including beverages and cleaning liquids,away from the OHM653. Liquid

4 OHM6532 Pull the monitor down into the viewing position. Grasp themonitor by the edges - do not press on the screen.

OHM653 5Note:• The OHM653 remote is always required to control the monitor -source unit remote controls do not operate the OHM653.To use rem

6 OHM653The [WIDE/ NORMAL] button changes the display mode from“wide” 16:9 mode to “normal” 4:3 mode. 4:316:9Note:• When using a

OHM653 76. INSTALLATION AND WIRING1. Before StartingRead these instructions and the following precautionscarefully.WARNING!Be sure to discon

8 OHM6534. Installing the OHM653Prepare the vehicle for installation by carefully removingvehicle interior trim panels as necessary. Route wire

OHM653 92. Determine if the mounting bracket can be attached to theroof beam through the dome light opening in the head-liner. This depends