Clarion CMD4A Manuel du propriétaire télécharger pdf (Page 14)

TUNER MODULE INSTALLAION

Select

area with sufficient ventilation for the mounting of the tuner module

order to prevent

the module from overheating.

You

may mount the module

a horizontal

vertical position.

If the module is mounted

a vertical position, do not mount the module with the harness exit

points directly facing up to prevent water collecting

these areas.

0 0

)

Please refer to the diagram below for the mounting screw hole positions. Always use the

shortest

len!:')th

of screw possible.

During installation, use the 4 rubber mounting stoppers (included

the package) for the bottom

of the module. This provides clearance from surface moisture and provides sufficient ventilation

for the heat sink.

Extension wires/cables may be needed to route the harness and cable throughout the vessel.

Note: Retain some slack

the harness!cables to prevent damage to the wires.

It is recommended relieve stress in

all

cables

and

harnesses.

Always read through the wiring diagram

this manual first, and follow all the wiring diagrams

carefully. The connections should be secured and insulated with crimp connectors or electrical

tape to ensure proper connections.

Once the wiring connections are completed, connect the negative terminal on the battery, turn

the vessel accessory ON and power on the unit to check if it

operating correctly.

If abnormalities occur, disconnect the battery negative terminal, recheck all wiring and try again.

Please refer to the troubleshooting section for assistance.

TUNER MOUNTING

•

• •

SCREW HOLE

M4 TAPPING SCREW

Dgf~-~ll

RUBBER -

STOPPER

4PCS

14 CMS1

1 2 ... 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Clarion CMD4A Manuel du propriétaire Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Électronique des véhicules automobiles Clarion CMD4A