Clarion ProSecurity RK20 Guide d'installation télécharger pdf (Page 21)

H1/9

WHITE (+/-) LIGHT FLASH OUTPUT

Important:

Do NOT connect this wire to a negative vehicle

light ﬂash wire before changing the programming jumper to

the negative polarity position or damage to the vehicle light

circuit may occur.

As factory conﬁgured, the H1/9 WHITE wire should be connected to the (+)

parking light wire. If the light ﬂash polarity jumper is moved to the (-) position

(refer to the Programming Jumper section of this guide), this wire then supplies

(-) 200mA output.

(+) Positive Light Flash Output

(-) Negative Light Flash Output

WHITE H1/11

(+) LIGHT FLASH OUTPUT

WHITE H1/11

(-) LIGHT FLASH OUTPUT

Note: For parking light circuits that draw 10-amps or more, the internal jumper

must be switched to a (-) light ﬂash output. (See Setting the light ﬂash polarity

section of this guide.) P/N 8617 or a standard automotive SPDT relay must be

used on the H1/2 light ﬂash output harness wire.

➤ Remote start harness, (H2) 5-pin connector

H2/1

BLACK/WHITE NEUTRAL SAFETY SWITCH INPUT

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Pas de commentaire

Clarion ProSecurity RK20 Guide d'installation Page 21